Breaking hammer relies on hydraulic power device to play the role of impact, hammering and crushing stones. Due to a series of advantages of wide application range and high work efficiency, it is widely used in mining, metallurgy, transportation, railway, tunnel and other industries. However, due to the characteristics of the breaker, there will always be some minor faults in use, such as poor impact continuity, which is a common fault in the actual operation and use of the breaker, and the occurrence of such faults will seriously affect the working performance of the breaker. Today, the editor will tell you about the reasons for the poor continuity of the breaker and the solutions, and you will continue to look down.

　　There are three main situations where the continuity of the hydraulic breaker is poor:

　　1. The oil passage is blocked, resulting in no high-pressure oil in the oil passage, and problems such as poor continuity;

　　2. Oil circuit faults, such as misconnection of oil pipes, insufficient pressure value, wrong direction of reversing valve, stuck piston, failure of stop valve, etc., which will cause problems such as insufficient impact force or impact stagnation;

　　3. The drill rod is stuck, and the continuity and periodicity are affected, resulting in problems with function and stability.

　　After understanding the reasons for the poor continuity, the following editor will tell you how to deal with this problem.

　　1. If there is poor continuity, the oil circuit of the breaker should be checked immediately, and the blocked parts should be cleaned or replaced in time.

　　2. To check the oil supply system of the hydraulic breaker, pay attention to the inspection of the oil pipe interface, the direction of the reversing valve, the stop valve, and the piston;

　　3. Check and adjust the state of the drill rod, and grind the drill rod with a problem with a grinding wheel or oil stone.

　　The above content is the reason and solution for the poor continuity that Hanyun Construction Machinery sorted out for you. I hope that everyone will do a good job in operation and daily maintenance while working on the breaker.